Click here to make tpub.com your Home Page

Page Title: Dimensions and clearances
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home

   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 




img
MIL-T-62357A
than 3 inches beyond the rear of the tank. When a pintle is furnished, the bumper shall be
constructed to allow for installation of a pintle assembly.
*  3.5.8 Fenders. The trailer shall have fenders over each wheel. The fenders shall prevent mud
and water from splashing on the tank. The top of the fenders shall be essentially flat. The top of
the fenders shall be fabricated of diamond tread steel or covered with abrasive-type paint
(ships grip). The top of the fenders shall be capable of rigidly supporting a 200 pound servicing
personnel standing on the top. The fenders shall be rigidly attached to the chassis frame. Rubber
mudflaps shall be installed to the rear of the wheels and shall conform to SAE J682. A metal strip
not less than 0.125 inch thick and not less than 1 inch wide, extending the entire width of the mud
flap, shall be installed to prevent the bolt heads or bolt nuts from damaging the mud flap. As an
alternate method of attaching the mud flaps, tabs or clips with minimum surface contact
dimensions of 1 inch high by 1.250 inch wide by 0.094 inch thick shall be furnished at each bolt.
Access steps and grab handles, to assist personnel in climbing on top of the fenders, shall be
provided.
3.5.9 Pintle. When specified (see 6.2), a pintle assembly conforming to MS 51335-2
(solid type) shall be installed on an adequately supported device at the rear of the chassis frame.
The rearmost portion of the pintle assembly shall project beyond the rear of the vehicle. Two
trailer safety chain attachment devices, one adjacent to each side of the pintle, shall be provided.
Each attachment device shall provide an ultimate strength of not less than 18,000 pounds and
shall be capable of accommodating a standard grab hook for a 0.375-inch chain (2.813 wide,
0.734 thick, and with a 0.484 throat diameter).
3.5.10 Lubrication. All moving parts of the equipment normally requiring lubrication shall be
provided with suitable means for such lubrication. The lubrication fittings shall be standard
commercial type with a surface-check ball.
3.5.11 Dimensions and clearances. The trailer, when uncoupled from the towing vehicle and
without payload, on level ground, shall conform to the dimensions specified in table II.
TABLE II. Trailer dimensions (inches).
Characteristic
Dimension
Overall width (maximum)
96
Overall height (maximum)
68
Overall length (without engine driven pump) (maximum)
168
Overall length (with engine driven pump) (maximum)
200
Ground clearance (minimum)
15
12

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business