 |
|||
|
Page Title:
Electric trailer brake controller |
|
||
| ||||||||||
|
|  MIL-T-62491C
brake control system shall conform to 3.4.11.3. The pintle height shall be in proportion to the
frame height.
3.1.1.9 Trailer lighting table. When specified (see 6.2), a trailer lighting cable conforming to
SAE J1067 shall be furnished. The cable shall be coiled and shall be not less than 2800 mm
(110 inches) long when fully extended. Both ends of the cable shall be equipped with a round
plug conforming to SAE J560. The plugs shall be equipped with a grip for withdrawing from the
connector sockets. The cable shall be packaged and stowed in the stowage box or compartment
(see 3.5.13(g), 3.6.12(h)).
3.1.1.10 Electric trailer brake controller. When specified (see 6.2), the vehicle shall be
provided with an electric trailer brake controller. The controller shall be installed in the truck cab
and wired through the SAE J560 lighting receptacle. The controller shall operate on the 12-volt
electrical system of the vehicle and shall include load control, hand lever, and accessories.
3.1.1.11 Silicone brake fluid. When specified for class 10 vehicles (see 6.2), and if available
as the manufacturer's standard or optional brake fluid, brake fluid conforming to MIL-B-46176
shall be provided in the hydraulic brake system. A tag shall be placed near the master cylinder
stating "CAUTION: USE SILICONE BRAKE FLUID ONLY, MIL-B-46176."
3.1.1.12 Hydraulic fluid identification plate. A decal or plate shall be installed near the
wrecker hydraulic system filler cap and shall identify the type of hydraulic fluid to be used.
(See 3.1.1.13).
* 3.1.1.13 Decals and data plates. The hydraulic fluid identification information and the power
takeoff caution notice shall be on a standard decal or plate from the supplier of that item or shall
conform to type I or type II, class 1 of MIL-M-43719 or composition A (class 1 or 2) or
composition C of MIL-P-514.
3.1.1.14 Brushguard. Model 4x4 and 6x6 vehicles shall be equipped with a radiator and
headlamp brushguard. When the headlights are recessed into and protected by the front bumper,
a headlamp brushguard is not required.
3.1.1.15 Brake lights. At least one pair of brake lights shall override the four-way emergency
flasher or the two systems shall be independent of each other. Modifications to the
manufacturer's standard product to accommodate this requirement shall not compromise
conformance to any Federal Motor Carrier Safety Regulation referenced herein or to any Federal
Motor Vehicle Safety Standard. If additional lights are added to the vehicle, the lights shall be
selected from the chassis manufacturer's standard matching hardware.
9
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals