 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-62518A
(f) Replacement headlights, if required to be added, shall meet the height requirement of
not less than 560 mm (22 inches) and not more than 1370 (54 inches), measured above
the road surface, in conformance with Federal Motor Vehicle Safety Standard No. 108.
Replacement headlights shall be equivalent in mounting, protection, and range and
precision of adjustment to the chassis manufacturer's original standard headlights.
(g) Unused headlight cavities are covered in a neat workmanlike manner, treated and
painted to match the chassis cab color with treatment and painting equivalent to the
chassis cab manufacturer's process for the remainder of the chassis cab. Cavities and
their covers shall be rustproofed in accordance with 3.1.1.2.
(h) Complete installation drawings are available to the procuring activity.
* 3.1.1.14 Brushguards. Model 4x4 vehicles shall be equipped with a radiator and headlamp
brushguard. When the headlamps are recessed into and protected by the front bumper, a head
lamp brushguard is not required.
* 3.1.1.15 Spark arrester. As specified herein (see 3.4.4.1), the vehicle shall be furnished with
an exhaust system spark arrester.
3.2 General design.
3.2.1 Federal Motor Vehicle Safety Standards. The vehicle and furnished accessories shall
comply with all Federal Motor Vehicle Safety Standards in effect on the date of manufacture.
3.2.2 Air pollution control. The vehicle shall comply with the EPA Regulations governing
Control of Air Pollution from New Motor Vehicles and New Motor Vehicle Engines in effect on
the date of manufacture. In addition, vehicles destined for California shall comply with State of
California regulations governing air pollution control in effect on the date of manufacture.
* 3.2.3 Sound level. The cab interior sound level shall not exceed 84 db(a) when measured in
accordance with Federal Motor Carrier Safety Regulation 393.94. The vehicle exterior drive-by
sound level shall conform to EPA Noise Emission Standards for Transportation Equipment -
Medium and Heavy Trucks.
* 3.2.4 Safety standards. The vehicle and rotating aerial device, the manufacturer, the other
contributing manufactuer's, dealers (when applicable) and installers (when applicable) shall
comply with ANSI A92.2. The vehicle shall comply with all OSHA requirements, including
OSHA 1926.556.
11
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals