 |
|||
|
Page Title:
Azimuth preamplifier and demodulator-Fixed Mode/Adjustment |
|
||
| ||||||||||
|
|  MIL-T-63534(AR)
Note: Details such as inputs/outputs, signal levels, pin connections, etc.,
for the tests specified below are in the referenced Section 3 paragraph. This
information is a pertinent part of each test specified.
4.6.2 Azimuth preamplifier and demodulator-Action Mode. Verify that the
azimuth demodulator output voltage (in the action mode) meets the specified
requirements of azimuth preamplifier and demodulator-Action mode and
associated table.
4.6.3 Elevation preamplifier and demodulator-Action Mode. Verify that
the elevation demodulator output voltage (in the action mode) meets the
specified requirements of Elevation preamplifier and demodulator-action mode.
4.6.4 Azimuth preamplifier and demodulator-Fixed Mode/Adjustment. Verify
that the azimuth demodulator output (in the fixed mode) can be adjusted and
meets the specified requirements of azimuth preamplifier and demodulator-Fixed
Mode/Adjustment.
4.6.5 Elevation preamplifier and demodulator-Fixed Mode/Adjustments.
Verify that the elevatlon demodulator output (In the fixed mode) can be
adjusted and meets the specified requirements of Elevation preamplifier and
demodulator-Fixed Mode/Adjustments.
4.6.6 Normal stow mode. Verify that the voltage specified in 3.6.1.2.3
meets the specified requirements of normal stow mode.
4.6.7 Azimuth output drive and control. Verify that the azimuth output
voltage meets the amplitude, width and repetitive rate of the specified
requirement for azimuth output drive and control and that the azimuth limit,
right and left signals disable their respective drive outputs.
4.6.8 Elevation output drive and control. Verify that the elevation
output voltage meets the amplitude, width and repetitive rate of the
specified requirement for elevation output drive and control and that the
elevation limit, right and left signals disable their respective drive outputs.
4.6.9 Gain characteristics. Verify that the azimuth and elevation output
gains meet the specified requirements of azimuth gain characteristics and
elevation gain characteristics (as related to deadband signals).
4.6.10 Deadband. Verify that the deadband meets the specified
requirements of deadband.
4.6.11 Drive output waveform characteristics. Verify that the azimuth
and elevation waveforms meet the specified requirements of Drive output
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals