 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-63535(AR)
4.4.14 Identification plate. Verify by observation that the
identification plate meets the requirements of drawing 905D490.
4.4.15 Workmanship. The requirements of 3.13 shall be verified
by continuous inspection of all parts and assemblies to assure
conformance to high quality workmanship.
4.5 Quality conformance inspection.
4.5.1 Lot formation. The term "inspection lot" is defined as a
homogeneous collection of units of product from which a
representative sample is drawn or which is inspected 100 percent to
determine conformance with applicable requirements. Units of
product selected for inspection shall represent only the inspection
lot from which drawn and shall not be construed to represent any
prior or subsequent quantities presented for inspection. Homogeneity
shall be considered to exist provided the inspection lot has been
produced by one manufacturer in one unchanged process, using the
same materials and methods, in accordance with the same drawings,
same drawing revisions, same specifications and same specification
revisions and complies with the provisions for submission of product
as specified in MIL-STD-105. All material submitted for inspection
in accordance with this specification shall comply with the
homogeneity criteria specified herein, regardless of the type of
inspection procedure which is being applied to determine conformance
with requirements. In addition, motors shall be from not more than
one lot from one manufacturer.
4.5.1.1 Spare parts lot. A spare part lot shall consist of
spare parts as produced concurrently by a manufacturing process
common to the lot. Each lot of spare parts shall not include more
than one lot of material where parts are subjected to heat treatment.
4.5.1.2 Replacement parts lot. A replacement parts lot shall
consist of all spare parts of the same design presented for
acceptance at one time, in which the unit of product is a part
manufactured separate from the process of assembled feed assemblies.
NOTE: An inspection lot shall not exceed one (1) month's production.
4.5.2 Examination. The examinations listed in the item detail
specification for Classification of Defects shall be performed on
inspection lots as defined in 4.5.1 of this specification.
Equipment necessary for the performance of the inspections shall be
listed in accordance with 4.5.5.
4.5.3 Sampling plans. Unless otherwise specified in the
Classification of Defects and Test Table, sampling plans for major
and minor defects shall be in accordance with MIL-sTD-105,
Inspection Level II.
12
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals