 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-81404B(AS)
4.9 Maintainability test. The Mean-Corrective-Maintenance-Time and
Maximum-Corrective-Maintenance as specified in 3.3.7 shall be demonstrated as
specified in MIL-STD-471, Test Method 9.
4.10 Test procedures. The procedures used for conducting first article
tests and quality conformance tests shall be prepared and made available by
the contractor for procuring activity review and acceptance. (see 6.2.2). The
right is reserved by the procuring activity or the government inspector to
modify the tests or require any additional tests deemed necessary to determine
compliance with the requirements of this specification and the contract (see
6.2.2). MIL-T-18303 shall be used as a guide for preparation of test
When approved test procedures are available from previous
procedures.
contracts, such procedures will be provided and may be used when their use is
authorized by the procuring activity. However, the right is reserved by the
procuring activity to require modification of such procedures, including
additional tests, when deemed necessary (see 6.2.1).
4.11 Presubmission testing. No item, part or complete test set shall be
submitted by the contractor until it has been previously tested and inspected
by the contractor and found to comply with all applicable requirements.
PACKAGING
5.
5.1 General.
All major un its and parts of the test sets shall be
preserved, packaged, packed and marked for the level of shipment specified in
the contract or purchase order in accordance with MIL-E-17555 (see 6.2.1).
NOTES
6.
6.1 Intended use. The AN/ASM-149C Guided Missile Launcher and Aircraft
Electrical Circuit Test Set AN/ASM-149C is intended for use to determine the
operational capability and safety of aircraft and launcher circuitry employed
in the launching of the AGM-45A (SHRIKE) missile.
6.2 Ordering data.
6.2.1 Acquisition
requirements. Acquisition documents should specify the
following:
Title, number, and date of this specification.
a.
b.
Selection of applicable levels of packaging and packing (see
5.1).
Whether first article inspection is required (see 3.1 and 6.3).
c.
d.
If additional individual tests are required (see 4.5.1).
e.
Lot acceptance for each lot, if other than specified in
4.5.3.2.1.
f.
Test procedure modification or if additional tests are required
(see 4.10).
19
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals