 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-81527B(AS)
as a work surface for various removable assemblies of the Test and
Control Rack.
3.4.1.6.2.4.3.2.2 Form Factor.
The Drop Leaf shall be installed on the
forward left edge of the Base Structure.
It shall provide nominal surface
area of 29 inches by 12 inches when extended, level with the Bench Top.
When folded, the Drop Leaf shall not protrude more than 1-1/4 inches from
the front of the Base Structure.
Latches and locking devices shall be in-
stalled to secure the Drop Leaf in either the extended or the folded position.
The surface of the Drop Leaf shall be fabricated from the same material as
the Bench Top.
3.4.1.6.2.4.3.3 Cradle Slide Assembly,
The Cradle Slide Assembly shall support the
3.4.1.6.2.4.3.3.1 Function.
Test Set MCS TS2511B/AWG-10 below the right front corner of the Bench
Top. This location will permit the use of the Test Set MGS TS2511C/AWG-10 in
the performance of tests associated with the AN/APG-59 Radar Set Assembly
Line Replaceable Units (LRU) installed on the Pallet Shaft Assembly and on
the RF Section Support Assembly.
The Cradle Slide Assembly shall secure
the Test Set MCS TS251lC/AWG-10 with its front panel upward and controls
easily accessible.
The Cradle Slide Assembly shall not
3.4.1.6.2.4.3.3.2 Form Factor.
exceed 24 inches by 14 inches by 9 inches when stowed. The Assembly shall
Latches shall be provided to secure
consist of two slide rails and a cradle.
the cradle in the stowed position.
The cradle shall pull out a nominal
12-7/8 inches from the front of the Base Structure for use in the extended
position.
3.4.1.6.2.4.3.4 Unregulated Power Supply Support.
The Unregulated Power Supply Support shall
3.4.1.6.2.4.3.4.1 Function.
support the Unregulated Power Supply, PP-455l/APG-59 in the horizontal
position above the deck.
The Support shall be at the right side of the Base
Structure beneath the Cradle Slide ASsembly.
12
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals