Click here to make tpub.com your Home Page

Page Title: Grounding Wand
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home

   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 




img
MIL-T-81527B(AS)
3.4. 1. 6.2.4.3.4.2 Form Factor.
The Power Supply Support shall consist
of two angle brackets a nominal 15- 1/4 inches long attached to the Base
Structure.
They shall support the power supply at a nominal 7-1/2 and
8 inches above the deck, front and rear respectively.
3.4. 1. 6.2.4.3.5 Grounding Wand.
A high-voltage Grounding Wand 19 + O.5
inches long shall be mounted on the Base Structure.
It shall be electrically
connected to the main ground bus of the bench and shall permit grounding of
all high voltage terminals of the RF Section of the AN/APG-59 Radar Set.
3.4. 1. 6.2.5 Rear Frame.
3.4.1.6.2.5.1 Function.
The Rear Frame shall form the rear and overhead
structure of the Receiver Section Bench Assembly. It shall provide the
upper attachment points for the Pallet Shaft Assembly, attachment points for
the Convenience Power outlet Installation, the Remote Safety Unit and a test
point bracket and brackets and clamps for the interface between the Inter-
connecting Test Harness and the System Harness.
The Rear Frame shall be attached to the
3.4. 1. 6.2.5.2 Form Factor.
rear of the Base Structure with its bottom edge a nominal 4 inches above
the deck.
The rear vertical portion of the frame shall be nominal 39 inches
The overhead structure shall not exceed 39
by 68 inches less attachments.
To improve access to the pallets, the
inches by 24- 1/2 inches by 3 inches.
Both the
sides of the overhead structure shall be cut back 12-7/8 inches.
vertical portion and overhead structure of the Rear Frame shall form an
The overhead structure shall support the upper end of
integral structure.
Latches shall be provided to secure the pallets
the Pallet Shaft Assembly.
of the AN/APG-59 Radar Set in the work position. An attachment point shall
be provided for the Remote Safety Switch on the structural member, which
The attachment
defines the right cut-back portion of the overhead structure.
point shall be provided for a test point bracket on the left portion of this same
member.
13

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business