Click here to make tpub.com your Home Page

Page Title: Tail assemblies
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home

   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 




img
MIL-T-41838(AS)
Contractor Order No.
Manufacturer's Name or Trademark
Tech. Dir. Compliance (Contractor to leave
blank space for future service use)
U.S. Property
Internal nameplate - A metal nameplate shall be securely affixed
3.5.2
to an internal structural component. The information to be included on the name-
plate shall be identical to that specified in paragraph 3.5.1 above. The nameplate
shall be visible and accessible through one of the access doors.
T a i l assemblies - The tank shall have provision for either a bob-
3.6
tail assembly or a long tail cone (see 6. 4).
B o b - t a i l assembly - The bob-tail assembly shall be smoothly
3.6.1
contoured and without fins.
Long tail cone assembly - The long tail cone assembly shall
3.6.2
have provisions for either 0, 2 or 4 fins. Provisions shall also permit mounting
the fins either vertically and horizontally, or at 45 degrees from the vertical.
(See 6.4.)
W e i g h t - The empty weight of the tank with two fins installed on
3.7
the long tail shall not exceed 200 pounds.
Float switch actuation - The tank float switch shall be actuated
3.8
at the following levels:
CAPACITY GALLONS
TANK ATTITUDE
285.0 to 291.0
a. 6 `nose up
0
288.0 to 294.0
b. 1 15' nose up
0
c. 1 20' nose down
277.0 to 283.0
A e r o d y n a m i c smoothness - Variation from the nominal contour
3.9
smoothness of the tank as shown on the applicable drawings shall not exceed the
dimensions shown herein when measured with a spline over the distance of six (6)
inches in any direction including weld bead height. The nominal dimension varia-
tion for the first third of the tank shall be .032 inches and .050 inches for the
remaining two-thirds of the tank. All external screws, rivets, etc., shall be flush.
Cleaning - Each tank component shall be thoroughly cleaned,
3.10
internally and externally, of dirt, sand, metal chips or other foreign matter while
being assembled. The tank shall be thoroughly cleaned of the above after assembly.
5

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business