 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-85472A(AS)
The CONTRAST control shall vary the contrast
3.6.2.2.2 CONTRAST control.
of the display.
The V LIN control shall control the vertical
3.6.2.2.3 V LIN control.
linearity of the raster.
The V SIZE control shall control the height of
3.6.2.2.4 V SIZE control.
the raster.
3.6.2.2.5 V HOLD control.
The V HOLD control shall stabilize the raster in
the vertical plane.
3.6,2.2.6 BRIGHTNESS control.
The BRIGHTNESS control shall vary the
brightness of the display.
3.6.2.2.7 H HOLD control.
The H HOLD control shall stabilize the raster in
the horizontal plane.
3.6.2.2.8 INPUT Z switch. The INPUT Z switch shall provide the capability
of selecting either HIGH or 75 ohms impedance for matching impedance of the
monitor input to the input signal.
3.6.3 Receiver drawer assembly. The receiver assembly shall be
manufactured in accordance with DL412AS9000 and shall meet the requirements
stated thereon and in 3.6.3.1 through 3.6.3.1.7.
3.6.3.1 Receiver assembly functions. The receiver assembly shall be
capable of receiving the video signal from the weapon under test and
demodulating the signal for display on the monitor (1A1). The front panel
of the receiver drawer assembly shall contain coaxial jacks, J2 (RCVR) and
J3 (XMTR), and the operator controls for the receiver.
3.6.3.1.1 RCVR J2 connector. Connector J2 shall provide a connection for
power meter 1A3 for measuring RF power level of weapon transmitter.
3.6.3.1.2 XMTR J3 connector. Connector J3 shall provide a connection for
power meter 1A3 to test set transmitter 1A4 TR1 for measurement of RF power
level.
3.6.3.1.3 RF channel control. The RF channel control shall provide the
capability of selecting any one of the five receiver center frequencies.
3.6.3.1.4 Power switch. The power switch shall apply the 115 volt ac, 60
Hz single phase voltage to the receiver assembly.
3.6.3.1.5 Meter function switch.
The meter function switch shall select
the signal strength or tuning.
3.6.3.1.6 Video level control.
Video level control shall adjust the output
video level.
3.6.3.1.7 Video output jack. The video output jack shall provide a monitor
connection for video level during calibration and weapon testing.
3.6.4 Power meter drawer assembly. The power meter assembly shall be
manufactured in accordance with DL412AS9000 and shall meet the requirements
stated thereon and in 3.6.4.1 through 3.6.4.2.7.
13
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals