 |
|||
|
|
|||
| ||||||||||
|
|  MIL-T-85472A(AS)
3.6.11.5 Cable assembly (W38).
This cable assembly shall be manufactured in
accordance with DL412AS9000.
This cable assembly shall be manufactured in
3.6.11.6 Cable assembly (W40).
accordance with DL412AS9000.
This cable assembly shall be manufactured in
3.6.11.7 Cable assembly (W50).
accordance with DL412AS9000.
Preparation, procedures and requirements for soldering of
3.7 Soldering.
electrical connections shall be in accordance with WS-6536.
3.8 Workmanship. The test set group, including all parts and accessories,
shall be manufactured in accordance with DL412AS9000 and as specified herein.
Workmanship shall meet the requirements of MIL-STD-454, Requirement 9.
4.
QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. Unless otherwise specified in the
contract or purchase order, the contractor is responsible for the performance
of all inspection requirements as specified herein.
Except as otherwise
specified in the contract or purchase order, the contractor may use his own or
any other facilities suitable for the performance of the inspection
requirements specified herein, unless disapproved by the Government. The
Government reserves the right to perform any of the inspections set forth in
the specification, where such inspections are deemed necessary to assure
supplies and services conform to prescribed requirements.
4.1.1 Responsibility for compliance. All items must meet all requirements of
sections 3 and 5. The inspection set forth in this specification shall become
a part of the contractor's overall inspection system or quality program. The
absence of any inspection requirements in the specification shall not relieve
the contractor of the responsibility of assuring that all products or supplies
submitted to the Government for acceptance comply with all requirements of the
contract.
Sampling in quality conformance does not authorize submission of
known defective material, either indicated or actual, nor does it commit the
Government to acceptance of defective material.
The inspection requirements specified
4.2 Classification of inspections.
herein are classified as follows:
a.
First article inspection (see 4.4)
b. Quality conformance inspection (see 4.5)
4.3 Inspection conditions. Unless otherwise specified herein, all
inspections shall be performed in accordance with the conditions specified as
follows:
a.
Temperature
Room ambient (25
b. Altitude
Normal ground
Vibration
None
c.
21
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals