 |
|||
|
|
|||
| ||||||||||
|
| MIL-V-17501F(SH)
5.1 Preservation, pocking, and marking. Valves shall be individually preserved level A or
C, packed level A, B, or C, and marked in accordance with MIL-V-3, as specified (see 6.2). The
identification of any preservative used, its method of application and the recommended procedure
for removal before placing the valve in service shall be contained on removal tags affixed to the
valve components concerned.
5.2 Cushioning, dunnage, and wrapping materials. Cushioning. dunnage. and wrapping
materials shall be as specified in 5.2.1 through 5.2.3.
5.2.1 Level A. Loose-fill type materials used for packaging and packing applications such as
cushioning, filler, or dunnage are prohibited for materials destined for shipboard installation or
stowage.
5.2.2 Level C. When loose-fill materials are used for packaging and packing applications such
as cushioning, filler, and dunnage, all containers (unit, intermediate, and shipping) shall be marked
or labelled with the following information:
CAUTION
Contents cushioned etc., with loose-fill material not to be taken aboard ship.
Remove the discard loose-fill material before shipboard stowage. If required,
recushion with cellulose material, bound fiber, fiberboard, or transparent flexible
cellular material.
5.2.3 Fire resistant. cushioning, filler, dunnage, and wrapping materials selected, shall have
properties (characteristics) resistant to fire.
6. NOTES
(This section contains information of a general or explanatory nature that may be helpful, but is
not mandatory.)
6.1 Intended use. The valves covered by this specification are intended for use in shipboard
fire protection sprinkler systems servicing on board magazines and hangar decks.
6.2 Acquisition requirements. Acquisition documents must specify the following:
a.
Title, number, and date of this specification
Issue of DODISS to be cited in the solicitation, and if required, the specific issue of
b.
individual documents referenced (see 2.1.1 and 2.2)
Type, class, and size required (see 1.2)
c.
Type II valve requirements (three-position or two-position) (see 3.5.3)
d.
Sizes and dimensions of type I, class 1 valves, if other than specified (see 3.6.1.1)
e.
Test fitting requirements (see 3.6.13)
f.
Marking of valve parts (see 3.11.2)
g.
Quantity and type of special tools (see 3.12)
h.
Level of preservation packing, and marking required (see 5.1).
i.
18
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals