 |
|||
|
|
|||
| ||||||||||
|
|  MIL-V-19069B
3.4 Design and construction. Valves shall be of the design, construc-
tion and physical dimensions specified (see 3.1). Valves furnished under this
specification shall conform to all the requirements of specification MIL-ti-
8775 except that in the case of conflict between the requirements of specifi-
cation MIL-H-8775 and this specification, the requirements of this specifi-
cation shall govern.
3.5 Marking. Valves shall be stamped with the military part number (see
1.2), the manufacturer's name or code symbol, and date code. The marking
shall be stamped on the body of the valve in accordance with the applicable MS
sheet.
4.
QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection,
Unless otherwise specified in the
contract or purchase order, the contractor is responsible for the performance
of all inspection requirements as specified herein. Except as otherwise
specified in the contract or purchase order, the contractor may use his own or
any other facilities suitable for the performance of the inspection require-
ments specified herein, unless disapproved by the Government. The Government
reserves the right to perform any of the inspections set forth in the specifi-
cation where such inspections are deemed necessary to assure supplies and
-
services conform to prescribed requirements.
4.1.1 Responsibility for compliance.
All items must meet all require-
ments of Sections 3 and 5. The inspections set forth in this specification
shall become a part of the contractor's overall inspection system or quality
program. The absence of any inspection requirements in the specification
shall not relieve the contractor of the responsibility of assuring that all
products or supplies submitted to the Government for acceptance comply with
all requirements of submission of known defective material, either indicated
or actual, nor does it commit the Government to acceptance of defective
material,
4.2 General. The qualification and quality conformance provisions con-
tained in Section 4 of specification MIL-H-8775 are applicable to, and form a
part of, this specification. In addition, the following quality assurance
provisions shall apply.
4.3 Inspection conditions.
4.3.1 Positioning. Unless otherwise specified, inspections may be con-
ducted with the valve axes in either of the following positions:
a.
Horizontal,
b.
Vertical (the force of gravity acting opposite to the
checking action),
3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals