 |
|||
|
Page Title:
Quality conformance inspecion sample |
|
||
| ||||||||||
|
|  MIL-V-82444A(OS)
*
4.3.2 Quality conformance inspecion sample. The sampling plans'" and
procedures set forth in MIL-STD-105 shall be used in the determination
of acceptability of the lot of valves inspected as specified in 4.5.6.4
and 4.5.6.5. In addition, a quantity of sample squibs equal to 10 percent
of the number of squibs assembled into the acceptance lot of valves shall
be submitted for acceptance testing as specified in 4.5.7 through 4.5.7.5.
4.3.3 Periodic production sample. Periodic production samples shall
be selected from units that have satisfactorily passed the quality
conformance inspections of "4.5. These samples shall be subjected to the
tests of 4.6 at an activity designated by the procuring activity.
Periodic production sampling shall be as follows:
Step 1. Upon initiation of production randomly select 3
units from each group of 30 units. Upon satisfactory
compliance of samples selected from 3 consecutive groups,
shift to step 2.
Step 2. Randomly select 3 units from each group of 70
units. Continue with Step 2 for the balance of the contract
or until a defective unit is found.
When a defective unit is found in any group, acceptance of all units on
hand shall be withheld and the contractor shall:
a. Determine the cause of the defect
b. Take the necessary actions to correct or eliminate the
defect from all units on hand and, if so directed by
the procuring activity, from those units previously
shipped.
c. Submit to the procuring activity, for approval, the
proposed corrective action to prevent recurrence of
the defect.
d. Submit to the procuring activity, for approval, the
proposed retest program to verify that the corrective
action eliminated the defect.
Return to Step 1 and proceed as indicated when inspection is
resumed.
7
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals