 |
|||
|
Page Title:
Nameplates and identification markings |
|
||
| ||||||||||
|
|  MIL-V-85830(AS)
3.14 Nameplates and identification markings. Nameplate approval,
equipment identification marking and serial number assignment, shall be as
specified in MIL-N-18307.
3.15 Configuration. The ventilator furnished shall be produced under a
program for managing system configuration as specified in DOD-STD-480,
MIL-STD-483 and MIL-STD-490.
3.16 Human engineering. Human performance and human engineering design
criteria for the ventilator shall be as specified in MIL-STD-1472.
3.17 Workmanship. The ventilator shall be uniform in quality and shall be
free from irregularities, defects, burrs, cracks, dents or foreign matter
which could adversely affect safety, performance, reliability or durability.
4.
QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. Unless otherwise specified in the
contract or purchase order, the contractor is responsible for the performance
of all inspection requirements as specified herein. Except as otherwise
specified in the contract or purchase order, the contractor may use his own or
any other facilities suitable" for the performance of the inspection
requirements specified herein, unless disapproved by the Government. The
Government reserves the right to perform any of the inspections set forth in
the specification where such inspections are deemed necessary to assure
supplies and services conform to prescribed requirements.
4.1.1 Responsibility for compliance. All items must meet all requirements
of sections 3 and 5. The Inspection set forth in this specification shall
become a part of the contractor's overall inspection system or quality
program. The absense of any inspection requirements in the specification
shall not relieve the contractor of the responsibility of assuring that all
products or supplies submitted to the Government for acceptance comply with
all requirements of the contract. Sampling in quality conformance does not
authorize submission of known defective material , either indicated or actual,
nor does It commit the Government to acceptance of defective material.
The inspection requirements specified
4.2 Classification of inspection.
herein are classified as follows:
a. Qualification inspection (see 4.3).
b. First article inspection (see 4.4).
Quality conformance Inspection (see 4.5).
Quality conformance verification Inspection (see 4.6).
4.3 Qualification Inspection. Qualification inspection shall be performed
in the order specified in Table I, consisting of all the tests and
examinations listed in this specification.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals