|
| MIL-W-48230 (PA)
or other means which provide sufficient information to permit identifi-
cation and evaluation by the Government and may include illustrations
and engineering data. Designs shall be prepared for any specific
fixture(s) required to be used with commercial equipment, or with
SIE designs if not otherwise covered thereby (see 6.2.1c).
Designs shall be of the category and form (per MIL-D-1000)
specified in the Contract Data Requirements Lists (DD Form 1423),
The contractor is referred to MIL-HDBK-204, "Inspection Equipment
Design" for guidance. The specification, paragraph, and defect
numbers from Section 4 of this specification shall be referenced
on each contractor design together with the component or assembly
drawing number and revision letter to which the specific design
applies.
6.3.3 Submission of designs for approval.-Contractor
designs shall be approved by the Government prior to fabricating
or procuring the equipment. Designs shall be submitted for
approval to Picatinny Arsenal, ATTN: SARPA-QA-A-R, Dover, N.J. 07801
in accordance with the stipulations, time frame and distribution
specified in the Contract Data Requirements Lists (DD Form 1423)
or in the contract. Partial submission of inspection equipment
designs is permissible and encouraged. However, the completion
date for design review will be based on the date of the final
submission of designs. Picatinny Arsenal design review will
normally be accomplished within one month after receipt.
6.4 Submission of First Article Sample.-Instructions as
to the submission and location for testing and evaluation of
the first article sample shall be obtained from the Contracting
Officer. Upon receipt of such request, the Contracting Officer
shall advise Picatinny Arsenal, and instructions will be issued
accordingly. All inquiries should be forwarded to:
Commander
Picatinny Arsenal
ATTN: SARPA-QA-I-Q
Dover, New Jersey 07801
27
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |