 |
|||
|
|
|||
| ||||||||||
|
|  MIL-W-50986A (AR)
Sampling Plan for Normal Inspection, Table IIA. The hardness
measurement shall be taken at the center of both faces of the
target material. Failure of one or more pieces of target material
to meet the hardness requirement shall be cause for rejection of
all the target material obtained from the original mill product.
All mechanical testing shall be performed on each mill product in
accordance with ASTM-A-370.
4.5 6 Data requirements. The contractor shall submit a
quality inspection test demonstration and evaluation report in
accordance with Data Item Descriptions DI-R-1721 and DI-R-1724
giving the detailed test results.
PACKAGING
5.
5.1 Packaging and packing. This specification covers the
loading only for 2.75 Inch Rocket, HEDP M247 Warheads. The
warhead is to be delivered as part of a complete round in
accordance with MIL-R-50263, unless otherwise specified in the
contract.
Data card information shall be as
5.2 Ammunition data cards.
specified in MIL-STD-1167.
6.0 NOTES
6.1 Intended use. The components covered by this
specification are intended for use on the 2.75 Inch Folding Fin
Aerial Rocket.
See MIL-A-48078.
6.2 Ordering data.
6.3 Submission of inspection equipment designs for approval.
See 6.2 of MIL-A-48078. Sumnit designs as required to Commander,
US Army Armament Research and Development Command, ATTN:
DRDAR-QAF-I, Dover, NJ 07801.
6.4 Data requirements. When this specification is used in an
acquisition which incorporates a DD Form 1423, Contract Data
Requirements List (CDRL), the data requirements identified below
shall be developed as specified by an approved Data Item
Description (DD Form 1664) and delivered in accordance with the
approved CDRL incorporated into the contract. When the provisions
18
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals