grease, rust, porosity, warpage, burn marks, checks, blisters,
excess flash, corrosion products and other foreign matter. The
cleaning method used shall not be injurious to any part nor shall
the parts be contaminated by the cleaning agents. Surface coating
shall be continuous except for a few slight scratches not exposing
base material. The loading and assembly operations shall be
performed in a thorough, workmanlike manner consistent with the
best practices of the industry. All required markings shall be
neat and legible.
3.21.2 Electrical. Cable assemblies and wires shall be
dressed in such manner as to prevent pinching or chafing of the
wire insulation. Ends of wires shall be free from flux, chips,
dirt, grease, rust or foreign material.
QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. Unless otherwise
specified in the contract, the Contractor is responsible for the
performance of all inspection requirements as specified herein.
Except as otherwise specified in the contract, the Contractor may
use his own or any other facilities suitable for the performance
of the inspection requirements specified herein, unless
disapproved by the Government. The Government reserves the right
to perform any of the inspections set forth in the specification
where such inspections are deemed necessary to assure supplies and
services conform to prescribed requirements. Unless otherwise
specified herein or in the contract, the provisions of MIL-A-48078
shall apply and are made a part of this specification.
4.2 Classification of inspections. Unless otherwise
specified herein, or in the contract, the following types of
inspection shall be conducted on this item:
First Article Inspection
Quality Conformance Inspection
4.3 First article inspection.
4.3.1 Submission. The contractor shall submit a first
article sample as designated by the Contracting Officer for
evaluation in accordance with the provisions of 4.3.2. The first
article sample shall consist of the following items in sample
quantities as indicated: