5.1 Packaging and marking.
5.2 Ammunition data cards.
Data card information shall be as
specified in MIL-STD-1167.
6.1 Intended use. The warheads covered by this specification
are intended for use as part of the 2.75 Inch Folding Fin Aerial
6.2 Ordering data.
6.3 Submission of inspection equipment for design approvals.
See 6.2 of MIL-A-48078. Submit designs as required to Commander,
US Army Armament Research and Development Command, ATTN:
DRDAR-QAF-I, Dover, NJ 07801.
6.4 Data requirements. When this specification is used in an
acquisition which incorporates a DD Form 1423, Contract Data
Requirements List (CDRL), the data requirements identified below
shall be developed as specified by an approved Data Item
Description (DD Form 1664) and delivered in accordance with the
approved CDRL incorporated into the contract. When the provisions
of DAR 7-104.9 (n) (2) are invoked and the DD Form 1423 is not
used, the data specified below shall be delivered by the
contractor in accordance with the contract or purchase order
requirements. Deliverable data required by this specification is
cited in the following paragraphs.
Data Requirement Title
Applicable DID No.
Quality Inspection Defect Report
Quality Inspection Test
and Evaluation Report
(Data item descriptions related to this specification, and
identified in section 6 will be approved and listed as such in DoD
5000.19L, Vol. II, AMSDL. Copies of data item descriptions
required by the contractors in connection with specific
acquisition functions should be obtained from the Naval
Publications and Forms Center or as directed by the contracting