 |
|||
|
|
|||
| ||||||||||
|
|  MIL-B-3461G
INT. AMENDMENT 6 (IH)
PAGE 12
Section 4:
Delete "4. Quality Assurance Provisions" and paragraphs 4.1 through 4.3.1 in their entirety
and substitute the following:
"4. VERIFICATION
4.1 Classification of inspections. The inspection requirements specified herein are classified
as follows:
a. First article inspection. Inspection and testing of the first article (see 3.2) shall be
made of a completely finished item or items for all provisions of this specification applicable to
the end product examination and tests (see 4.3.3 and 4.3.4).
b. Conformance inspection. Inspection shall be in accordance with the provisions set
forth herein, except where otherwise indicated (see 6.2). Sampling for inspection shall be
performed in accordance with ANSI/ASQC Z1.4.
4.2 Inspection conditions. Unless otherwise stated, all inspections shall be performed in
accordance with the test conditions specified in 4.3.
4.3 Methods of inspection.
4.3.1 Testing of components. See TABLE V, below:
TABLE V. Testing of components.
RESULTS
COMPONENT
CHARACTERISTIC
RQM'T
TEST METHOD
REPORTED AS
copper base alloy
chemical composition
3.3.1
4.4.1
nearest 1%"
PAGE 15
Paragraph 4.3.3.1.1:
Under "Assembly" in TABLE VI, change the third defect to read - "Looseness; shell edge not
closed in, securely clinching the back. (Rotation of back within closed shell shall not exceed 10
degrees maximum.)"
PAGE 16
Paragraph 4.3.3.1.1 - Add the following to TABLE VI:
Classification
Major (*) Minor
Examine
Defect
Staple type
Not material specified. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
--
--
X
prong
Not properly swedged or soldered. . . . . . . . . . . . . . . . . . . .
--
--
X
9 of 15
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals