 |
|||
|
|
|||
| ||||||||||
|
|  MIL-B-70511B (AR)
5.1 Packing. The M2 Bolt shall be packed in accordance with
drawing P11833491.
5.2 Marking and labeling. Packing boxes shall be marked and
labeled in accordance with drawing, P11833491.
6. NOTES
(This section contains information of a general or explanatory
nature that may be helpful, but is not mandatory.)
6.1 Intended use. The M2 Bolt replaces the standard M16
series Rifle bolt to enable short range training ammunition to be
fired.
6.2 Acquisition requirements. Acquisition documents must
specify the following:
a. Title, number and date of this specification and all
applicable Quality Assurance Provisions (QAP's).
b. Issue of DODISS to be cited in the solicitation, and
if required, the specific issue of individual documents
referenced (see 2.1.2).
Requirements for submission of first article sample.
c.
d.
Applicable stock number.
Packaging requirements, if other than specified in
Section 5.
f.
Serialization requirements, if applicable.
Certificate of conformance for each lot or shipment of
g.
product.
h. Quality Conformance Inspection, if other than
specified in Section 4 of specification.
i. The packages opened for examination shall be
repackaged by the contractor at the contractor's expense.
Disposition of tested M2 Bolt.
j.
k. Responsibility for test firing facilities and
operating procedures.
6.3 Submission of contractor inspection equipment designs
for approval. Submit copies of designs as required to:
Commander, U.S. Army ARDEC, ATTN: SMCAR-QAF-S, Picatinny
Arsenal, NJ 07806-5000. This address will be specified on the
Contract Data Requirements List, DD Form 1423 in the contract.
18
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals