 |
|||
|
|
|||
| ||||||||||
|
|  MIL-B-70776 (AR)
TABLE I.
End item visual defects. (cont'd)
Classification
Defect
Examine
Major
Minor
x
Location
markings
Drilled
l
Printed marking more than 1/32 inch
in width
x
Any spot or stain clearly noticeable
x
Cleanness
Not trimmed to 1/4 inch maximum length
Thread ends
x
4.4.4 Fit examination. The end item
shall be examined for the
defects listed below. The lot size shall
be expressed in units of
bandoleer. The inspection
bandoleers. The sample unit shall be one
level shall be S-3 and the AQL, expressed
in terms of defects per
hundred units, shall be 0.65.
Defect
Examine
Bandoleers too small, i.e., mine fails to fit
Fit of mine
properly within the bandoleer.
into bandoleer
and closure of
flap
The mine shall be inserted into the bandoleer
with the pin side up and facing outboard whether
in either pocket.
NOTE: It shall be possible to insert the mine within
the bandoleer pocket without effort other than
that necessary to overcome friction between the
mine and the pocket. A defect shall be scored if
the mine must be forced into the pocket.
Bandoleer, pocket body or flap too short, causing
inability to secure snap fastener without applying
excessive force.
NOTE: With the two mines in the bandoleer pockets, the
pocket flaps shall be closed and the snap
fasteners, shall be secured. It shall be possible
to secure the snap fastener without effort other
than that necessary to secure the male and female
components. A defect shall be scored if it is
necessary to force either flap down in order to
secure the fastener.
10
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals