 |
|||
|
|
|||
| ||||||||||
|
|  MIL-B-81205(WP)
3.1.3 Preproduction Samples - Unless otherwise specified
in the contract or order (see 6.2), preproduction samples of the
Handling Band shall be manufactured using the methods and pro-
cedures proposed for production. The sample will be tested as
specified in Section 4 herein and is for the purpose of determining
that, prior to starting productions the contractor's production
methods are capable of yielding items that comply with the
technical requirements of the documents noted in 3.1.2.
3.2 Performance requirements and product characteristics -
Handling Bands covered by this specification shall be capable of
meeting-the following performance requirements and product
characteristics:
3.2.1 Static load requirements
3.2.1.1 Handling Band structure - There shall be no
evidence of structural failures visible damage, or permanent
deformation when a load of 7,000 pounds is placed on the Handling
Band as described in 4.4.1.
3.2.1.2 Lifting holes - There shall be no evidence of
structural failures visible damages or permanent deformation
when the Handling Band has been secured to a mandrel 13 inches
in diameter and a load of 4,500 pounds is applied through the
lifting holes (one-half the load to each hole, simultaneously)
and maintained for one (1), minute (see 4.4.2).
3.3 No data is required by this specification or by
documents referenced in Section 2, unless specified in the
contract or order (see 6.2).
3.4 Workmanship - Workmanship in the fabrication and
assembly of the Handling Bands shall be of sufficiently high
quality to assure that completed equipment will comply with all
requirements of this specification. Particular attention shall
be paid to plating, painting, marking, and freedom of parts from
burrs and sharp edges. The assembled Handling Bands shall be
thoroughly clean of all dirt, chips, and other foreign matter.
The standards of workmanship exhibited in any preproduction
sample, subject to any qualification stated in the Government's
notice of approval, shall be determinative of the requirements
of the contract relative to workmanship insofar as not specif-
ically covered by applicable specifications.
-3-
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals