 |
|||
|
|
|||
| ||||||||||
|
|  MIL-B-81793/24
Design. All bearings described by this specification
1.
sheet shall be angular contact insstrument bearings with a
flanged, non-separable and counterbored outer ring on flange
side.
Material. The ball and ring material for these bearings
2.
shall be corrosion resistant steel 440C (UNS S44004) conforming
to QQ-S-763.
Tolerance class. The tolerance class shall be in accordance
3.
with the ABEC 7P tolerance tables of ANSI/AFBMA Standard 12.2. This
tolerance class shall apply to all bearing sizes listed in Table I
of this specification sheet.
4. Boundary dimensions l The boundary dimensions shall be as
specified by the dash number (DASH NO) in Table I.
Retainer. The retainer shall be as specified by the part
5.
number designator (PN DES) in Table 11.
closures l Closures are not available for this type of
6.
bearing l Part number designator N shall be used as shown in
Table 111.
Radial internal clearance or contact angle. Radial internal
7.
clearance or contact angle shall be as specified by the part n*
designator in Table IV.
Calibration. Calibration shall be as specified by the part
8.
number designator in Table V.
Performance Test. The performance test shall be as specified
9.
by the part number designator in Table VI.
10.
Lubrication.
10.1. Lubricant. The lubricant shall be in accordance with the
specification indicated by the part number designator in table WI.
10.2. Lubricant amount. The amount of lubricant shall be as
specified by the part number designator in Table VIII.
10.3. Barrier coating. Barrier coating shall be applied to bearings
as specified by the part number designator in Table VII.
2
.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals