 |
|||
|
|
|||
| ||||||||||
|
|  MIL-B-81793/7
REQUIREMENTS
1.
Design.
Shall be deep
Material. The ball and ring material for these bearings
2.
shall be corrosion resistant steel 440C (UNS S44004).
Tolerance class. The tolerance class shall be in accordance
3.
with the ABEC 5P tolerance tables of ANSI/AFBMA Standard 12.2. This
tolerance class shall apply to all bearing sizes listed in Table I
of this specification sheet.
Boundary dimensions. The boundary dimensions shall be as
4.
specified by the dash number (DASH NO) in Table I.
Retainer. The retainer shall be as specified by the part
5.
number designator (PN DES) in Table II.
Closures. Closures shall be as specified by the part number
6.
designator in Table III.
Radial internal clearance. The radial internal clearance
7.
shall be as specified by the part number designator in Table IV.
Calibration. Calibration shall be as specified by the part
8.
number designator in Table V.
Performance Test. The performance test shall be as specified
9.
by the part number designator in Table VI.
Lubrication.
10.
10.1. Lubricant. The lubricant shall be in accordance with the
specification specified by the part number designator in Table VII.
10.2 lubricant amount. The amount of lubricant shall be as
specified by the part number designator in Table
VIII.
bearings
10.3. Barrier coating. Barrier coating shall
as specified by the part number designator in
2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals