 |
|||
|
|
|||
| ||||||||||
|
|  MIL-C-11272D
w/Amendment 1
5. PACKAGING
*
5.1 Packaging. For acquisition purposes, the packaging requirements shall be as specified in the contract or order
(see 6.2). When packaging of materiel is to be performed by DoD or in-house contractor personnel, these personnel
need to contact the responsible packaging activity to ascertain packaging requirements. Packaging requirements
are maintained by the Inventory Control Point's packaging activities within the Military Service or Defense Agency, or
within the military service's system commands. Packaging data retrieval is available from the managing Military
Department's or Defense Agency's automated packaging files, CD-ROM products, or by contacting the responsible
packaging activity.
6. NOTES
(This section contains information of a general or explanatory nature that may be helpful, but is not mandatory.)
6.1 Intended use. These capacitors are intended for use in any equipment where known orders of reliability are
required, and are primarily designed as a substitute for mica-dielectric capacitors as a step toward conservation of
critical mica. They are effective substitutes for mica-dielectric capacitors and can be employed for many applications
where mica-dielectric capacitors are used, provided consideration is given to the differences in temperature
coefficient and dielectric loss. They are capable of withstanding environmental conditions of shock, vibration,
acceleration, extreme moisture, vacuum, extended life of 30,000 hours and more, and high temperatures such as
experienced in missile-borne and space electronic equipment.
6.2 Acquisition requirements. Acquisition documents must specify the following:
a.
Title, number, and date of this specification.
b.
Issue of DoDISS to be cited in the solicitation, and if required, the specific issue of individual documents
referenced (see 2.2)
c.
Packaging requirements (see 5.1).
*
6.3 Qualification. With respect to products requiring qualification, awards will be made only for products that are,
at the time of award of contract, qualified for inclusion in Qualified Products List whether or not such products have
actually been so listed by that date. The attention of the contractors is called to these requirements, and
manufacturers are urged to arrange to have the products that they propose to offer to the Federal Government
tested for qualification in order that they may be eligible to be awarded contracts or orders for the products covered
by this specification. Information pertaining to qualification of products may be obtained from the Defense Supply
Center, Columbus, ATTN: DSCC-VQP, PO Box 3990, Columbus, OH 43216-5000, or by e-mail to vqp.mp@dla.mil.
6.3.1 Copies of "Provisions Governing Qualification" may be obtained upon application to Document Automation
and Production Service, Building 4D (DPM-DoDSSP), 700 Robbins Avenue, Philadelphia, PA 19111-5094.
6.4 Substitution data. The capacitors specified herein are not for use in design after the date of this specification.
They are authorized for use in design contracts effective on or before the date of this specification, and to support
existing military equipment. Capacitors specified in MIL-PRF-23269 are preferred for design and regardless of the
failure rate designation can be used as substitutes for the inactive capacitors of the same capacitance value,
tolerance, rated voltage and temperature coefficient.
*
6.4.1 Test data. For the purpose of verification of qualification and conformance inspection (see 4.4.4 and 4.5),
test data on identical items covered by MIL-PRF-23269 may be used.
6.5 Part or Identifying Number (PIN). This specification requires a PIN that describes codification and/or
classification and appropriate references to associated documents (see 1.2 and 3.1).
17
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals