 |
|||
|
Page Title:
Appendix B Engineering Drawings Technical Content Requirements |
|
||
| ||||||||||
|
|  MIL-C-18087A(SH)
APPENDIX B
ENGINEERING DRAWINGS TECHNICAL CONTENT REQUIREMENTS
SCOPE
10.
10.1 Scope. This appendix covers the technical content requirements that
should be included on drawings when required by the contract or order. This
appendix is mandatory only when data item description DI-DRPR-80651 is cited on
the DD Form 1423.
20.
APPLICABLE DOCUMENTS
20.1 Government documents.
20.1.1 Specifications. standards. an d handbooks. The following specifica-
tions , standards, and handbooks form a part of this document to the extent
specified herein. Unless otherwise specified, e issues of these documents are
th
those listed in the issue of the Department of Defense Index of Specifications and
Standards (DODISS) and supplement thereto, cited in the solicitation.
SPECIFICATIONS
MILITARY
MIL-T-31000 - Drawings, Engineering and Associated Lists
(Unless otherwise indicated, pies of federal and military specifications,
co
standards, and handbooks are available from the Standardization Documents Order
Desk, BLDG. 4D, 700 Robbins Avenue, Philadelphia, PA 19111-5094.)
30.
DRAWINGS
30.1 Drawing desire information
Drawings shall contain sufficient design
information to permit shipbuilders to make a satisfactory installation onboard
ship and to design supporting systems. This information shall include, but not be
limited to, the following:
(a) Mass moments of inertia for the clutch rotating parts in operating
condition about three mutually perpendicular axes with the origin
at the center of gravity of the unit as mounted. Orientation of
the axes shall be indicated with respect to the equipment and ship
with one axis being the longitudinal axis of the clutch.
(b) Axial, lateral, and torsional stiffness of the clutch in operating
condition.
(c) Interface dimensions and location.
(d) Lifting points and required loads.
(e) Outline drawings and assembly drawings as applicable shall contain
the outline dimensions, weights, and center of gravity locations
for the clutch and controller. A notation of any change in weight
or location of center of gravity due to modifications listed in
the revision columns of the drawing shall also be listed therein
37
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals