 |
|||
|
Page Title:
Slaving Amplifier Output and Gain |
|
||
| ||||||||||
|
| MIL-C-38418E(AS)
For Pitch Channel Tests
S1 to 19
S2 to 20
S3 to 21
For Roll Channel Tests
S1 to 22
S2 to 23
S3 to 24
f. Connect a 1000 0.1% ohm resistor between each of the
following connector (2J2) pinsper table III:
From 17 to 9
From 18 to 9
g. Connect 400 Hz input power to the following connector (2J1)
pins per table V:
Neutral
to
23
115V A
to
24
115V B
to
25
115V C
to
26
Connect 78V C through a spring-loaded normally open switch
h.
to connector 2J2-4 with the neutral (unstitched) to 2J2-9 or equivalent
ground.
4.6.4.1 SlavingAmplifier Output and Gain - The slaving amplifier output
and gain shall be checked as follows:
Set the controls on the simulated controller and electronic
a.
control amplifier as follows:
Mode switch to SLAVED
Latitude control to 0
Hemisphere switch to N
Compensation switch to OFF
b.
Set the simulated azimuth detector to 0 and the simulated
displacement gyroscope heading transmitter to 0.
54
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals