TABLE II. Temperature conditioning.
Temperature ( F)
-60 to -70
65 to 75
195 to 205
4.4.4 First article failure. Failure of the sample to comply with the requirements of the
drawings and specifications shall result in first article sample disapproval.
4.5 Quality conformance inspection.
126.96.36.199 Submission of product. The product shall be submitted in accordance with
188.8.131.52 Lot size. The production lot size shall be as specified in the contract (see 6.2).
4.5.2 Examination and tests. The quality conformance sample shall be subjected to the
examinations of 4.6 and all the test procedures of 4.7 except for 4.7.7.
4.6 Examination. All cartridges and components shall be examined visually and
radiographically and characteristics defined in accordance with the applicable drawings. One
hundred percent examination shall be performed for all critical defects. Examination for major
or minor defects shall be performed on a defect basis in accordance with the classification of
defects. Inspection for elastomeric O-rings shall be in accordance with MIL-STD-413. Four power
(4X) magnification may be used in performing visual examination for such defects as burrs and
foreign matter. When compliance is in doubt as a result of visual inspection, the characteristic
shall be measured or gaged to determine acceptability. All nonconforming items shall be rejected.
4.6.1 Cartridge, Impulse, M43 Assembly, Drawing 8593275.
Method of Inspection
Any part missing
Primer not properly seated
Marking missing, incorrect, or illegible