 |
|||
|
|
|||
| ||||||||||
|
|  MIL-C-50734(MU)
8 August 1973
4.3 Inspection provisions
4.3.1 Submission of product. Unless otherwise specified herein,
or by the contracting officer, inspection lot size, lot formation and
presentation of lots shall be in accordance with inspection and sampling
procedures herein and submission of product provisions of MIL-STD-105.
4.3.2 Examination a n d tests
4.3.2.1 Components a n d subassemblies. All components and sub-
assemblies shall be inspected in accordance with the inspection provisions
contained in the respective specifications and Supplementary Quality
Assurance Provisions (SQAP) listed in the technical data package (TDP).
In the absence of SQAP'S, the applicable quality assurance provisions of
MIL-F-13926 shall apply.
4 . 3 . 2 . 2 F i r s t a r t i c l e t e s t i n g . First article testing shall be
conducted in accordance with tables VII through IX , to determine
compliance with 4.2. All examinations and tests shall be witnessed
by the Government Quality Assurance Representative. When manu-
facturing processes, materials, or inspection techniques previously
applied are subject to change, or an adverse change occurs in perform-
ance capability of the unit, this shall be cause to cease those operations
contributing to the change or failure until corrections have been made
by the contractor and approved by the government.
4.3.2.3 Function tests.
The requirements and tests in table
shall be inspected on a 100 percent basis. All examinations and tests
shall be conducted at the standard ambient temperature.
4.4 Special sampling. The selection of samples shall be in
accordance with section 7 of MIL-STD-105.
One unit shall be selected at random by a
4.4.1 General.
Government representative as a control sample from each 50 produced.
The control sample shall meet the requirements and tests in table VIII.
14
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals