 |
|||
|
Page Title:
Control, Power Supply, Laser C-9135 ( ) / VVG -1: 11738831 |
|
||
| ||||||||||
|
|  INCH-POUND
MIL-C-50743(AR)
AMENDMENT 3
30 April 1991
SUPERSEDING
AMENDMENT 2
17 November 1976
MILITARY
SPECIFICATION
CONTROL,
POWER SUPPLY, LASER:
C9135(
) VVG-1: 11738831
This amendment forms a part of MIL-C-50743(AR), dated 8
August 1973, and is approved for use by the U.S. Army
Armament,
Munitions,
and
Chemical
Command,
and
is
available for use by all Departments and Agencies of the
Department of Defense.
PAGE 3
3.2.1, at end of paragraph, add:
"Soldering of
printed wiring assemblies
in
accordance
with
MIL-S-
46844 is the
preferred method."
PAGE
10
Figure
4:
Delete
"1.8
0.8
msec"
and
substitute
"1.8
1.0
msec".
PAGE
12
*
Figure
5:
Delete
"*0.6
0.3
sec"
and
substitute
*0.8
0.6
sec"
Delete note "*At the temperature extremes
-----
shall
be
0.6
O. 5
sec." in its entirety and substitute:
"*At the
temperature extremes of 3.3.2.2 the pulse width shall be
100 60
msec, and the pulse spacing shall be 0.8 0.4 sec"
NOTE: The margins of this amendment are marked with an asterisk or
vertical lines to indicate where changes (additions, modifications,
corrections, deletions) from the previous amendment were made. This
was done as a convenience only, and the Government assumes no
liability whatsoever for any inaccuracies in these notations.
Bidders and contractors are cautioned to evaluate the requirements
of this document based on the entire content irrespective of the
marginal notations and relationship to the last previous amendment.
Custodian:
Preparing Activity:
Amy - AR
Army - AR
(Project
1240-AB16)
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals