 |
|||
|
|
|||
| ||||||||||
|
|  MIL-C-60985A (MU)
4.4.2 Hardness. -The test shall be conducted in accordance with Method
243 of Federal Standard No. 151. This is a nondestructive test. Parts so
tested may be returned to the lot.
4.4.3 Salt spray. -The applicable parts shall be tested in accordance
with FED-STD-151, Method 811.1. This test shall be conducted for 240 hours.
Parts so tested shall not be returned to the lot. Salt solution shall be
5 per cent.
4.4.4 Total vent hole area (alternate method). -The cartridge case shall
be inspected for total vent hole area, using the equipment specified on the
Equipment List. This test is a non-destructive test. Parts so tested may be
returned to the lot.
5. PREPARATION FOR DELIVERY
5.1 Preservation and packaging.-
5.1.1 Level C. -The metal parts for Case, Cartridge, M118, shall be
packaged for shipment as described below:
5.1.1,1 Case, Cartridge, M118. -Five hundred (500) cases shall be packed
base down in five (5) layers in Type 1, Class 1, "B" Flute, 175 pound minimum,
domestic Class, RSC Style, Specification PPP-B-636 fiberboard box. Inside di-
mensions of fiber box shall be 18 3/4 X 18 3/4 X 9 3/4 high ( 1/16 tol).
Each layer shall be composed of an egg crate type separator in a 10 X 10
pattern. Separators shall fit snug in fiber box, length and width. Height of
separator to 1 1/2 inches. A filler 18 X 18 shall be used between layers and on
top as required for tight packing. Material used for separators and fillers
shall be the same as that used for the fiber box.
5.1.1.2 Base plug and powder charge cup. -The base bluff and powder charge
cup shall be packed as specified in MIL-STD-1169
5.1.1.3 Alternate pack for Case, Cartridge, M118. -Three hundred (300)
cases shall be packed in six (6) layers in Type 1, Class 1, "B" flute, 175 pound
minimum, domestic class, RSC Style, Specification PPP-B-636 fiberboard box.
Inside dimensions of fiber box shall be 17 1/2 X 8 3/4 X 11 5/8 high. Each layer
shall be composed of an egg crate type separator in a 10 X 5 pattern. Separators
shall fit snug in fiber box, length and width. Height of separator to be 1 1/2
inches. A filler 17 X 8 shall be used between layers, and on top as required
for tight packing. A spacer 8 5/8 X 8 5/8 shall be placed between flaps on
bottom and on top of fiber box. Material used for separator, fillers and spacers
shall be the same as that used for fiber box.
11
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals