 |
|||
|
|
|||
| ||||||||||
|
|  MIL-c-62202B(AR)
3.4 Environmental.
3.4.1 Shock. The assembly shall be capable of operating as specified
herein after exposure under the conditions of 3.1.3 to three half sine wave
shock pulses of 20 3 gravity units (g) for a duration of 18 3 milliseconds
(msec) applied in each direction along three mutually perpendicular axes. In
addition $ the assembly shall be capable of withstanding three sawtooth shock
pulses of 40 4 g for a duration of 9 1.5 msec applied in each direction
along three mutually perpendicular axes. (See 4.6.3.1)
3.4.2 Vibration. The assembly shall be capable of operating as specified
herein after exposure under the conditions of 3.1.3 to the vibration profile
of figure 2. Duration of exposure shall be not less than 80 minutes in each
of three mutually perpendicular axes. (See 4.6.3.2)
3.4.3 Operating temperature. The assembly shall be capable of operating
as specified herein over the operating temperature range of -25F to
+125F. (See 4.6.3.3, 4.6.3.4 and 4.6.3.5)
3.4.4 Storage temperature. The assembly shall be capable of operating as
specified herein after exposure to storage temperatures ranging from -65F
to +160F. (See 4.6.3.3, 4.6.3.4 and 4.6.3.5)
4. QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. Unless otherwise specified in the
contracts the contractor is responsible for the performance of all inspection
requirements as specified herein. Except as otherwise specified in the
contract , the contractor may use his own or any other facilities suitable for
the performance of the inspection requirements specified herein, unless disap-
proven by the Government. The Government reserves the right to perform any of
the inspections set forth in the specification where such inspections are
deemed necessary to assure supplies and services conform to prescribed
requirements l
4.2 Classification of inspections.
The inspection requirements specified
herein are classified as follows:
1. First article inspection (see 4.4).
2. Quality conformance inspection (see 4.5).
4.3 Inspection conditions. Unless otherwise specified? all inspections
shall be performed in accordance with the quality assurance provisions of
MIL-F-13926 and the conditions of 3.1.3.
10
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals