 |
|||
|
|
|||
| ||||||||||
|
|  MIL-c-62202B(AR)
4.5.3.2 Acceptance. Acceptance and rejection shall be in accordance with
M1L-STD-105O
4.5.4 Inspection plan C.
4.5.4.1 Sample and tests. Each assembly in every lot shall be subjected
to all the tests in table Iv and shall be examined visually for completeness
improper assembly and evidence of poor workmanship.
4.5.4.2 Acceptnce. Where any one assembly fails to meet any specified
requirement the defective assembly shall be removed from the lot and
resubmitted only after all defects have been corrected.
4.5.5 Inspection equipment. Unless otherwise specified in the contract,
the contractor shall supply, maintain and calibrate inspection equipment in
accordance with the provisions of MIL-I-45607 and MIL-STD-45662.
4.5.6 Packaging inspection. The sampling and inspectio of the
preservation - packaging, packing ad container marking shall be in accordance
with the provisions of packaging data sheet P11743439.
4.6 Methods of inspection.
4.6.1 Test equipment. Unless the assembly is procued apart from the
next higher assembly$ the test equipment in table VII shall be used where
specified to perform the required test.
TABLE VII. Test equipment.
4.6.2 Performance tests.
4.6.2.1 Continuity. Use items 1, 2 and 5 of table V1l or suitable
equipment to determine compliance with 3.3.1.
14
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals