|
| ![]() MIL-C-62202B(AR)
4.6.3.3 High temperature. Subject the assembly to the high temperature
test specified in MIL-STD-810, method 501.1, procedure I. The highest
operating temperature shall be 125F. The performance tests of table IV
shall be applied.
4.6.3.4 Low temperature. Subject the assembly to the low temperature
test specified in MIL-STD-81O, method 502.1, procedure I. The storage
temperature shall be -65F. The lowest operating temperature shall be -25F.
The performance tests of table IV shall be applied.
4.6.3.5 Temperature cycling. With power and loads of table I applied,
subject the assembly to the temperature profile specified in figure 3. At the
conclusion of this test, subject the assembly to the performance tests of
table IV.
5. PACKAGING
5.1 Packaging, packing and marking. Packaging, packing and marking shall be
in accordance with packaging data sheet P11743439. The level of protection shall
be as specified in the procurement document. (See 4.5.6)
6. NOTES
6.1 Intended use. The Commanders Control Circuit Card Assembly is used for
the display of range and returns for the Laser Fire Control Range Finder (AN/VVG-2).
6.2 Ordering data. Procurement documents should specify the following:
a. Title, number, and date of this specification.
b. Special tests and examination as required, the type of inspection
required, and the activity responsible for testing and its facility.
c. Applicable packaging data sheet number (See 5.1).
d. Selection of applicable levels of preservation, packaging, and packing:,
e. Applicable stock number.
f. First article inspection requirements.
6.3 Previous revisions of MIL-C-62202B was for the US Army Armament Research
and Development command's internal use only, and were not forwarded to the Naval
Publications and Form Center for publication.
Preparing Activity:
custodian:
Army-AR
Army-AR
Project 1240-A773
17
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |