 |
|||
|
|
|||
| ||||||||||
|
|  MIL-C-62204B(AR)
4.5.2.3 Acceptance. Where any one assembly of either sample fails to
meet any specified requirement, the lot shall be rejected. Rejected lots
shall be subject to the provisions of MIL-STD-105.
4.5.3 Inspection plan B.
4.5.3.1 Sample and tests. The sample shall be selected by the Government
representative in accordance with the provisions of MIL-STD-105. All the
tests in table VI and only the test of item 307 in table VII shall be applied.
4.5.3.2 Acceptance. Acceptance and rejection shall be in accordance with
MIL-STD-105.
4.5.4 Inspection plan C.
4.5.4.1 Sample and tests. Each assembly in every lot shall be subjected
to all the tests in table V and shall be examined visually for completeness,
improper assembly and evidence of poor workmanship.
4.5.4.2 Acceptance. Where any one assembly fails to meet any specified
requirement, the defective assembly shall be removed from the lot and
resubmitted only after all defects have been corrected.
4.5.5 Inspection equipment. Unless otherwise specified in the contract,
the contractor shall suPPlY, maintain and calibrate inspection equipment in
accordance with the provisions of MIL-I-45607 and MIL-STD-45662.
4.5.6 Packaging inspection. The sampling and inspection of the
preservation - packaging, packing and container marking shall be in accordance
with the provisions of packaging data sheet P11743281.
4.6 Methods of inspection.
4.6.1 Test equipment. Unless the assembly. is procured apart from the
next higher assembly, the test equipment in table VIII shall be used where.
specified to perform the required test.
23
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals