 |
|||
|
|
|||
| ||||||||||
|
|  MIL-C-62205B(AR)
3.3 Performance. Unless otherwise specified, the assembly shall meet the
performance requirents specified herein under standard ambient conditions of
3.1.3.
3.3.1 Continuity. With no power or signals applied, circuit resistance
shall be as follows: (See 4.6.2.1)
a. Direct continuity, resistance equal to or less than 2.0 ohms,
shall exist between pins P1-7 and P1-12, pins P1-11 and P1-30,
pins P1-13 and P1-31 and pins P1-13 and P1-29.
b. Resistances between pins P2-13 and P2-16 and pins P2-14 and P2-31
shall be 1.205 kilohms +0.15 percent.
c. Resistances between pins P2-16 and P2-17 and pins P2-14 and P2-17
shall be 95.2 ohM +0.75 percent.
d. Resistance between pins P2-17 and P2-18 shall be 50 kilohms +0.10
percent.
e. Resistance between pins P1-5 and P2-26 shall be 1.0 0.1 kilohms.
f. Resistance between pins P1-l and P1-2 shall be:
1. 360 36 kilohms, at 125F.
2. 450 25 kilohms, at 75 15F.
3. 584 58 kilohms, at -25F.
3.3.2 A-trigger. With the digital type-A signal (item 3.1 of table I)
applied between pins P2-27 and P1-7 as specified on figure 19 the outputs
between pins P1-16 and P1-79 pins P1-17 and P1-7, and pins P1-35 and P1-7 shall
have the characteristics specified on figure I. (See 4.6.2.2)
3.3.3 Video signal. With the digital type-A signal (item 3.1 of table I)
applied between pins P1-37 and P1-7 as specified on figure 2, the outputs
between pins P1-18 and P1-7 and pins P1-19 and P1-7 shall have the character-
istics specified on figure 2. (See 4.6.2.3)
4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals