 |
|||
|
|
|||
| ||||||||||
|
|  MIL-C-62205B(AR)
4.6.3.1.2 High intensity. Use items 3 and 4 of table V or mount the
l saambly in a suitable shock fixture and subject it to the shock test
specified in MIL-STD-810, method 516.2, procedure IV, figure 516.2-1. Apply
three sawtooth shock pulses in each direction along the three axes. Peak
amlitude shall be 40 4 g with a time duration of 9 0.2 msec measured at the
10 percent amplitude points. At the conclusion of this test, subject the
assembly to the performance tests of table II.
4.6.3.2 Vibration. Vibration A as specified in 4.6.3.2.1 shall be
conducted only for first article inspection. Vibration B as specified in
4.6.3.2.2 shall be conducted only for quality conformance inspection.
4.6.3.2.1 Vibration A. Use item 4 of table V or mount the assembly in a
suitable vibration fixture and subject the assembly to the vibration test
specified in MIL-STD-81O, method 514.2 procedure VIII, except that the test
level shall be the vibration curve shown in figure 6 and duration of exposure
shall be not less than 80 minutes per axis. At the conclusion of this test,
subject the assembly to the performance tests of table II.
4.6.3.2.2 Vibration B. This test shall be conducted as in 4.6.3.2.1
except that the period of vibration shall be not leas than 15 minutes in each
axis~
4.6.3.3 High temperature. Use item 6 of table V or suitable equipment
and subject the assembly to the high temperature test specified in
MIL-STD-810, method 501.1, procedure I. The highest operating temperature
shall be 125F. The performance tests of table II shall be applied.
4.6.3.4 Low temperature. Use item 6 of table V or suitable equipment and
subject the assembly to the low temperature test specified in MIL-STD-81O,
method 502.1, procedure I. The storage temperature shall be -65F. The
lowest operatiug temperature shall be -25F. The performance tests of table
II shall be applied.
4.6.3.5 Temperature cycling. With power and loads of table I applied,
subject the assembly to the temperature profile specified in figure 7. At the
conclusion of this test, subject the assembly to the performance test of
table II.
5. PACKAGING
5.1 Packaging, packing and marking. Packaging, packing and marking shall
be in accordance with packaging data sheet Pl1743417. The level of protection
shall be as specified in the procurement document. (See 4.5.6)
19
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals