 |
|||
|
|
|||
| ||||||||||
|
|  MIL-C-62207B(AR)
3. REQUIREMENTS
3.1 Fabrication. The digital to analog converter circuit card assembly,
herein referred to as the assembly, shall be manufactured in accordance with
Drawing 11743667 and drawings pertaining thereto and, when assembled, shall
meet the requirements of this specification. (See 4.5.1)
3.1.1 Function. The assembly shall provide output voltages as specified
from designated input conditions.
3.1.2 General specifications. The following provisions of MIL-P-13926
apply: (See 4.5.1)
a.
Order of precedence
b.
Dimensions and tolerances
c.
Inorganic protective surface finishes
d.
Part identification and marking
e.
Workmanship
3.1.3 Ambient conditions. Standard ambient conditions shall be as
follows:
73 18F
a. Temperature
50 percent 30 percent
b. Relative humidity
28.5 + 2.0 -3.2 in. Hg.
c. Atmospheric pressure
3.2 First article. When specified (see 6.2), the contractor shall
furnish sample units for first article inspection and approval (see 4.4 and
6.2).
3.3 Performance. Unless otherwise specified, the assembly shall meet the
performance requirements specified herein under standard ambient contion of
3.1.3.
3.3.1 Output voltage. with the laser range signal (item 3.2) of table I
input conditions established for each item of table II in the item number
order, and with the logical one strobe signal (item 3.1) of table I applied at
completion of establishment of laser range signal input conditions for each
item, the corresponding output voltage at pin A31 shall be as specified in
table II. (See 4.6.2.1)
3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals