 |
|||
|
|
|||
| ||||||||||
|
|  MIL-C-62207B(AR)
3.4 Environmental.
3.4.1 Shock. The assembly shall be capable of operating as specified
hesrein after exposure under the conditions of 3.1.3 to three half sine wave
shock pulses of 40 4 gravity units (g) for a duration of 18 3 milliseconds
(msec) applied in each direction along three mutually perpendicular axes. In
addition, the assembly shall be capable of withstanding three half sine wave
shock pulses of 100.0 10.0 g for a duration of 1.5 0.2 msec applied in
each direction along three mutually perpendicular axes. (See 4.6.3.1)
3.4.2 Vibration. The assembly shall be capable of operating as specified
herein after exposure under the conditions of 391.3 to the vibration Profile
of figure 1. Duration of exposure shall be not less than 80 minutes in each
of three mutually perpendicular axes. (See 4.6.3.2)
3.4.3 Operating temperature. The assembly shall be capable of operating
as specified herein over the operating temperature range of -25F to
+140F. (See 4.6.3.3, 4.6.3.4 and 4.6.3.5)
3.4.4 Storage temperature. The assembly shall be capable of operating as
specified herein after exposure to storage temperatures ranging from -65F
to +160F. (See 4.6.3.3, 4.6.3.4 and 4.6.3.5)
4. QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. Unless otherwise specified in the
contract, the contractor is responsible for the performance of all inspection
requirements as specified herin. Except as otherwise specified in the
contract, the contractor may use his own or any other facilities suitable for
the performance of the inspection requirements specified herein, unlcess
disapproved by the Government. The Government reserves the right to perform
any of the inspections set forth in the specification where such inspections
are deemed necessary to assure supplies and services conform to prescribed
requirements.
4.2 Classification of inspections. The inspection requirements specified
herein are classified as follows:
1. First article inspection (see 4.4).
2. Quality conformance inspection (see 4.5).
4.3 Inspection conditions. Unless otherwise specified, all inspections
shall be performed in accordance with the quality assurance provisions of
MIL-F-13926 and the conditions of 3.1.3.
7
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals