 |
|||
|
Page Title:
Cable Assemblies, Electrical, Fabrication Specification |
|
||
| ||||||||||
|
|  MIL-C-63550E (AR)
30 September 1985
SUPERSEDING
MIL-C-63550D (AR)
8 July 1983
MILITARY SPECIFICATION
CABLE ASSEMBLIES, ELECTRICAL, FABRICATION SPECIFICATION FOR
This specification is approved for use by the U.S. Army Armament, Munitions
and Chemical Command, Department of the Army, and is available for use by all
Departments and Agencies of the Department of Defense.
1.
SCOPE
1.1 Scope. This specification establishes the requirements for manufacture
and acceptance of electrical cable assemblies.
APPLICABLE DOCUMENTS
2.
2.1 Issues of documents. The following documents of the issue in effect on
date of invitation for bids or request for proposal form a part of this speci-
fication to the extent specified herein.
SPECIFICATIONS
MILITARY
- Preservation, Methods of
MIL-P-116
- Parts, Equipment and Tools for Army
MIL-P-14232
Materiel, Packaging and Packing of
MIL-C-22520
- Crimping Tools, Terminal, Hand, Wire
Termination, General Specification for
- Insulation Sleeving, Electrical, Heat
MIL-I-23053/5
Shrinkable, Polyolefin, Flexible,
Crosslinked
Beneficial comments (recommendations, additions, deletions) and any pertinent
data which may be of use in improving this document, should be addressed to:
Commander, US Army Armament, Munitions and Chemical Command, ATTN:
AMSMC-TDA-S(D), Dover, New Jersey 07801-5001 by using the self-addressed
Standardization Document Improvement Proposal (DD Form 1426) appearing at
the end of this document or by letter.
FSC 1010
Approved for public release; distribution is unlimited.
DISTRIBUTION STATEMENT A.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals