Control, Indicator, For Dispenser and Mines: Ground M131

• Control, Indicator, For Dispenser and Mines: Ground M131
• Specifications
• Standards
• Requirements
• Environmental conditions.
• Circuit continuity.
• Lamp driver output voltage.
• Safe/arm switch resistance.
• Stress screening
• Classification of inspection.
• Rejection.
• Control Indicator
• Control Indicator - Continued
• Inspection lot formation
• Core, Antenna - Ferrite
• Antenna, Receiver - RF
• Capacitor, Fixed, MICA Dielectric
• Capacitor, Fixed
• Capacitor, Fixed, Ceramics, Dielectric
• Printed Wiring Board
• Microcircuit, Linear, Amplifier
• Microcircuit, Digital, Decoder
• Synchronizer, Command Output
• Filter, Band Pass
• Capacitor, Variable, Vertical Mount
• Spacer, Insulator
• Terminal, Stud
• Transistor (JAN 2N869A)
• Semiconductor Device, Diode JAN IN5712
• Resistor, Fixed, Composition
• Capacitor, Fixed, Electrolynic Tantalum, Solid
• Crystal, Quartz
• Eyelet, Metallic
• Circuit Card Assembly, Receiver, Radio Frequency
• CCA, Radio Frequency (Performance Characteristics) (Ambient)
• CCA, Radio Frequency (Performance Characteristics) (-35 F, +0/-5 F)
• CCA, Radio Frequency (Performance Characteristics) (145 F, +5/-0 F)
• Insulator (Transitor)
• Microcircuit, Linear, Bipolar Monolithic Mircopower Voltage Detector
• Transistor, Field Effect
• Microcircuit, Digital, CMOS, Quad
• Printed Wiring Board
• Transformer, R.F.
• Microcircuit, CMOS Monolithic
• Thyristor (JAN2N682)
• Semiconductor Device, Diode JAN IN978B
• Transistor (JAN 2N2222A)
• Resistor, Fixed
• Resistor, Fixed, Film
• Terminal, Feedthru, Insulated
• Post, Binding, Electrical
• Switch, Rotary
• Light, Indicator
• Coil, Magnetic Coupling
• Circuit Card Assembly, Digital Logic
• CCA, Digital Logic (Performance Characteristics) (Ambient)
• CCA, Digital Logic (Performance Characteristics) (- 35 F, +0/- 5 F)
• CCA, Digital Logic (Performance Characteristics) (145 F, +5/- 0 F)
• Pin, Keying
• Contact Baterry
• Plate, Electrical
• Cable Assembly, Power, Electrical
• Bracket, Mounting - Rear
• Bracket, Mounting - Front
• Housing Control Indicator (Machined Part)
• Housing Control Indicator (Machined Part) - Continued
• Housing Control Indicator (Casting)
• Plunger, Spring Loaded
• Shaft, Rotary Switch
• Shaft, Rotary Switch - Continued
• Ratchet, Detenting
• Valve, Pressure Relief
• Panel, Battery
• Terminal, Pin
• Pin Plate Assembly, Coil - MCD
• Core, Ferrite
• Coil, Magnetic Coupling
• Control Indicator (Performance Charateristics)
• Control Indicator (Performance Charateristics) (-35 F, +0/-5 F)
• Control Indicator (Performance Charateristics) (145 F, +5/ - 0 F)
• Semiconductor Device, Diode JAN 1N5552
• Semiconductor Device, Diode JAN 1N5614
• Semicondutor Device, Diode, JAN 1N5806
• Capacitor
• Resistor, Network
• Dimensional control of molded or plastic parts.
• Initial input connections.
• Address verify functional test
• Test connections
• Lamp driver output voltage test.
• Accelerated arm sequence test.
• Power source
• Quiescent current test
• Hardwire deploy reverse polarity test
• Figure 2. Typical EBI Sequence Timing
• Figure 3. Tube Driver Output and FSD Sequence Characteristics
• Figure 5. Detonator Pulse Characteristics
• Figure 6. Tube Driver Output Load Circuit
• Figure 7. DEP, DATA and - FCL Waveforms
• Figure 8. MCD Waveform
• RF deploy with incorrect group ID
• Packaging
• Drawings
• Instructions
• Standardization Document Improvement Proposal
• Blank Page
• Blank Page
• Blank Page

Control, Indicator, For Dispenser and Mines: Ground M131

Privacy Statement - Press Release - Copyright Information. - Contact Us