 |
|||
|
|
|||
| ||||||||||
|
|  MIL-C-70494(AR)
4.6.4 Common connector contact continuity. This test shall
be conducted with no external power connected to the interface.
Measure with
ohm meter the resistance between the connector
contacts specified in 3.2,1.7. All measured resistances shall be
as specified in 3.2.1.7.
4.6.5 Workmanship. The interfaces shall be subjected to a
visual and tactile examination for evidence of faulty
The assembly shall conform to the requirements of
workmanship.
3.6.
The requirement for reliability
4.7 Reliability testing.
test approval and the responsibility (Government or contractor)
for reilability testing shall be as specified in the contract.
The sample for reliability test shall consist of 3 interfaces.
The samples shall be manufactured in the same manner, using the
same materials, equipment, processes, and procedures as will be
used in the production of the balance
the contract quantity.
All parts and materials, including packaging and packing, shall be
obtained from the same source of supply as will be used in the
production of the balance of the contract quantity.
4.7.1 Government testinq. When the Government is responsible
for conducting reliability tests the contractor Prior to
submitting the sample to the Government, shall inspect the sample
to assure that it conforms to all requirements of the contract and
submit a record of this inspection with the sampler including
certificates of conformance for all materials.
4.7.2 Contractor testinq. When the contractor is responsible
for conducting reliability tests, the sample shall be inspected
and tested by-the contractor for all the requirements of the
The sample and a record of these inspections and tests,
contract a
including certificates of conformance for all materials~ shall be
submitted to the Government for approval. The Government reserves
the right to witness any or all of the contractors reliability
tests and inspections.
PREPARATION FOR DELIVERY
5.
5.1 Delivery requirements. Handling, packaging, packing,
shipping, and marking of the Audio Interface Circuit Card
Assembly, 9355830 shall be in accordance with Packaging Data Sheet
9355830. The level of protection shall be as specified in the
procurement document.
NOTES
6.
6.1 Intended use. The interface described herein is intended
for use in the MBC. See drawing 11785850. "
11
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals