 |
|||
|
|
|||
| ||||||||||
|
|  MIL-C-70724(AR)
(Copies of other Government documents, drawings and
publications required by contractors in connection with specific
acquisition functions should be obtained from the contracting
activity or as directed by the contracting activity.)
2.2 Non-Government publications. The following documents
form a part of this document to the extent specified herein.
Unless otherwise specified, the issues of the documents which are
DOD adopted are those listed in the issue of the DODISS
cited in the solicitation. Unless otherwise specified, the
issues of documents not listed in the DODISS are the issues of the
documents cited in the solicitation (see 6.2).
American National Standards Institute
-Dimensioning and Tolerancing
ANSI - Y14.5-82
(Application for copies should be addressed to ANSI, 1430
Broadway, New York, N.Y. 10018)
2.3 Order of precedence. In the event of a conflict between
the text of this document and the references cited herein, the
text of this document takes precedence. Nothing in this document,
however, supersedes applicable laws and regulations unless a
specific exemption has been obtained.
REQUIREMENTS
3.
3.1 General. The cartridge shall comply with the require-
ments specified on drawing 12598560, referenced specifications and
the requirements stated in this section. All of the cartridge
components shall be compatible with each other. The primer mix
shall be non-corrosive and the propellant shall be smokeless. The
cartridge shall be compatible with the 5.56mm M27 link, 5.56mm 10-
round stripper clip, the 5.56mm 20 and 30 round magazines the SAW
ammunition container as well as the bolts, chambers, barrel bores
and gas and feed systems of the weapons specified in 3.4.5. The
cartridge shall present no operational problems in the field.
3.2 Qualification. When specified in the solicitation,
contract or purchase order, a sample shall be submitted for
qualification in accordance with the technical provisions
specified herein (see section 4.3). The purpose of qualification
is to verify that a particular contractor's design is capable of
meeting the requirements of this specification. Such
qualification does not, in any way, relieve the contractor of his
contractual obligation to deliver items meeting all requirements
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals