 |
|||
|
|
|||
| ||||||||||
|
|  MIL-C-70726A (AR)
TABLE VI (Cont.)
double the quantities specified for the function and casualty
test, shall be fired. If the total number of defects in the
combined first and second samples exceeds the acceptance number
for the cumulative sample, the lot shall be rejected. If, in
testing a second sample, defects other than those for which the
second sample is being tested should occur to the extent that the
acceptance number for the cumulative sample is exceeded, the lot
shall be rejected. If no acceptance number is listed for the
cumulative sample, no second sample shall be permitted.
For location of defects indicated in parenthesis, see
drawing 7643674.
*****************************************************************
4.5.5 Packaging, packing, and marking inspection.
Inspection for linking, packaging, packing and marking shall be
IAW MIL-STD-644 as applies to the drawing or as required by the
contract.
The inspection equipment
4.5.6 Inspection equipment.
required to perform the examination and test prescribed herein is
described in the Inspection Reference column in the Qualification
tables, First Article examination tables, and Quality Conformance
Inspection Classification of Characteristics paragraphs.
contractor shall submit inspection equipment designs for approval
by the Government IAW the terms of the contract. See section 6
of MIL-A-48078 and 6.3 herein.
4.6 Methods of inspection.
Performance characteristics.
4.6.1
*
4.6.1.1 Primer sensitivity. Test IAW the procedure
specified in Section 7-25 of TECP 700-700 Vol III using the
rundown method with 50 primers at each height except that
cartridge cases from the submitted lot shall be used using the
equipment shown on EL8658292.
4.6.1.2 Residual stress.
*
4.6.1.2.1 Cartridges with brass cases. Test IAW paragraph
14 of Section 7-24 of TECP 700-700 Vol III using the equipment
shown on EL8654131.
Testing not
4.6.1.2.2 Cartridges with steel cases.
required.
4.6.1.2.3 Cases of other materials. Test IAW procedures
approved by the Government appropriate to the material(s) used to
manufacture the cartridge.
27
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals