 |
|||
|
|
|||
| ||||||||||
|
|  MIL-C-70726A (AR)
6.3 Submission of contractor inspection equipment designs
(See MIL-A-48078). Submit copies of designs as
for approval.
required to: Commander, ARDEC, ATTN: SMCAR-QAF-I (D), Picatinny
Arsenal, N.J. 07806-5000. This address will be specified on the
Contract Data Requirements List (CDRL), DD Form 1423 in the
contract.
6.4 Submission of test data. In addition to the normal
distribution of records, when the cartridge is procured by the US
Army AMCCOM, one copy of all ballistic data and the Ammunition
Data Card for each lot shall be forwarded to: Commander, ARDEC,
ATTN: SMCAR-QAF-S (D), Picatinny Arsenal, N.J. 07806-5000.
6.5 Hazard notice. The cartridge described herein and some
of the cartridge components are flammable and explosive and,
therefore, present hazards in manufacture, handling, storage, and
shipment. the contractor shall -recognize these hazards and shall
take appropriate measures to prevent fire, explosion, adverse
environmental, rough handling, corrosive atmosphere, and
electrically induced incidents. Such measures shall include the
employment of an effective safety program that addresses the
inherent hazards associated with the cartridge.
6.6 Drawings. Drawings listed in Section 2 of this
document under the heading US Army Armament Research,
Development, and Engineering Center (ARDEC) may also include
drawings prepared by and identified as Edgewood Arsenal,
Frankford Arsenal, Rock Island Arsenal, U.S. Army Armament
Research and Development Command (ARRADCOM), or Picatinny Arsenal
drawings. Technical data originally prepared by these activities
is now under the cognizance of ARDEC.
6.7 Definitions.
The number of successes (rounds
6.7.1 Reliability.
chambered, fired, and ejected) divided by the number tested.
occasionally the last round of a continuous belt, due to the
light weight of the cartridge case, will not fully eject from the
weapon. This type of failure shall not be classified as a weapon
stoppage nor shall this type of failure be recorded as a defect
chargeable to the ammunition.
6.8 Submission of alternative quality conformance
provisions. Unless otherwise specified in the contract, any
proposed alternative quality conformance provisions will be
submitted by the contractor for evaluation by the technical
activity responsible for the preparation of this specification.
35
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals