 |
|||
|
|
|||
| ||||||||||
|
|  MIL-C-70785 (AR)
4.3.4 Testing. The tests listed in Quality Conformance
Inspection shall be performed on each cartridge lot in accordance
with the test methods prescribed in 4.4. Unless otherwise
indicated, tests shall be conducted with samples at 21 3C.
Sample size and acceptance criteria for each test shall be as
specified. only cartridges having met the visual and dimensional
requirements and having been selected in such a manner that the
sample is representative of the entire lot shall be used in the
tests. The selected cartridges shall be thoroughly mixed before
being divided into samples for the various tests. The combining
of tests is permitted (see 6.4).
4.3.4.1 Firing efects and casualties. Firing defects and
associated criterla shall be as specified in Table I. For the
defect definitions see AS12013566.
4.3.4.2 Unlisted firing defects. The lot shall be suspended
and referred to the contracting officer for disposition if a
malfunction or casualty not covered by this specification occuring
in any firing test, indicates that the product may be unsuitable
for the purpose intended.
MIL-STD-644
4.3.5 Packaging,packing and marking inspection.
shall be used as a guide for inspection of packaging, packing and
marking as applicable to Dwg. 12013674.
4.3.6 Inspection equipment. Inspection equipment required to
perform examinations and tests prescribed herein shall conform to
the provisions of MIL-A-48076.
4.4
Methods of inspection.
The method shall be as
4.4.1 Projectile extraction.
prescribed in AS12013566.
4.4.2 Propellant contamination. The propellant from each of
the cartridges will be examined visually for contamination, as
prescribed in AS12013566.
4.4.3 Projectile torque. Each cartridge of the test sample
shall be marked axially across the rotating band onto the case
neck. Torque, to the specified requirement, shall be applied
slowly to the projectile. Movement of the projectile with respect
to the cartridge case detectable by misalignment in the scratch
mark, shall be recorded.
4.4.4 Velocity, pressure, and waterproofness. The methods of
test shall be as prescribed in AS12013566. Atotal of three
barrels shall be utilized for EPVAT testing, Ten (10) rounds
shall be fired through each barrel on day one. An additional ten
15
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals