 |
|||
|
|
|||
| ||||||||||
|
|  2.2 Non-Government publications. The following documents form a part of this document
to the extent specified herein. Unless otherwise specified, the issues of the documents
which are DoD adopted are those listed in the issue of the DODISS cited in the solicitation.
Unless otherwise specified, the issues of documents not listed in the DODISS are the issues
of the documents cited in the solicitation (see 6.2.).
American Society for Testing and Materials
ASTM D 70
Specific Gravity of Road Oils, Road Tars, Asphalt Cements,
and Soft Tar Pitches
ASTM D 395
Compression Set of Vulcanized Rubber
ASTM D 1084
Viscosity of Adhesives
ASTM D 2471
Gel Time and
Peak Exothermic Temperature
of
Reacting
Thermosetting Plastic Compositions
(Application for copies should be addressed to American Society for Testing and
Materials, 1916 Race Street, Philadelphia, Pa. 19103.)
Society of Plastics Industry, Inc.
ERF 22
Method of Test for Determination of Thermal Conductivity of
Cured Epoxy Resins Systems
(Application for copies should be addressed to Society of Plastics Industry, Inc.,
Epoxy Resin Formulation Division, 253 Park Ave., New York, N.Y. 10017.)
(Non-Government standards and other publications are normally available from the
organizations that prepare or distribute the documents.
These documents also may be
available in or through libraries or other informational services).
2.3 Order of precedence. In the event of a conflict between the text of this document
and the references cited herein, the text of this document takes precedence. Nothing in
this document, however, supersedes applicable laws and regulations unless a specific
exemption has been obtained.
3.
REQUIREMENTS
3.1
General.
3.1.1 Qualification. The polymeric compound furnished under this specification shall
be a product which meets all the requirements specified herein and has been listed on or
approved for listing on the applicable qualified products list at the time set for opening
of bids (see 4.3 and 6.4).
3.1.2 Material. The two-component material shall polymerize in situ at room temperature
when thoroughly blended together in equal parts by weight. The thermosetting compound may
contain a hydroxy-modified, polydiene-isocyanate system polymerized by a curing agent, with
asphalt as a filler material.
3.1.3 Workmanship. The individual components shall contain no volatiles nor toluene
diisocyanate ingredient (TDI) and shall be products of high quality, suitable for the
purpose intended, and so manufactured as to meet all the requirements specified herein.
Both components furnished under this specification shall be uniform in quality and
consistency after stirring and free of agglomerates or foreign particles. The cured compound
shall be free of low or high density areas and shall present an appearance of smooth
homogeneity.
3.1.4
Storage (shelf) life.
The cured compound (see 6.3.2) shall meet all the
requirements of this specification when produced from components that have been stored in
unopened original containers no longer than 8 months at ambient temperature.
3.2
Product characteristics.
3.2.1
Physical properties of components.
The components shall have the physical
properties specified in table I.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals