 |
|||
|
Page Title:
International system of units (SI) |
|
||
| ||||||||||
|
|  MIL-D-19326H
Indicating instruments
Leakage
Line valve
Liquid oxygen
Liquid oxygen converters
Mask to regulator hoses
Portable units
Pressure decay
Purging
Regulator
Relief valve
Shutoff valve
Tubing
* 6.5 International system of units (SI). The ASTM E 380-74, Metric Practice
Guide - A Guide to the Use of SI, the International System of Units. was used for
the conversion to the SI units in this document. The-following conversion factors
are applicable to this specification.
Foot X 0.3048
=
Metre (m)
3
Litre per hour x 2.77 x 10-7 6
=
Cubic metre per sec (m 3/s)
Litre per minute X 16.7 X 10-
=
Cubic metre per sec (m /s)
Pounds per square inch (psi) X 6.894
=
Kilopascals (kPa)
Degrees Fahrenheit (F)
=
Degrees Celcius (oC) X 1.8 + 32
Inches X 25.4
=
Millimetres (mm)
Inch-pounds X 0.1130
=
Newton-metre (N-m)
Litres per minute X 16.667
=
Cubic centrimetre per sec
(cu. cm/s)
Millimetres of mercury X 0.1333
= Kilopascals (kPa)
Inches of water X 248.18
= Pascals (Pa)
* 6.6 International standardization. Certain provisions of this specification
are the subject of International standardization agreement (ASCC 11/1, ASCC 25/27,
ASCC 25/30 and STANAG 3499). When amendment, revision, or cancellation of this
specification is proposed which will modify the international agreement concerned,
the preparing activity will take appropriate action through international
standardization channels, including departmental standardization offices, to
change the agreement or make other appropriate accommodations.
* 6.7 Streamlining. For MIL-D-19326H acquisitions, the required portions of all
MIL-D-19326H tier reference documents shall be limited to the portions described
in the "Applicability" column of Table I in Appendix A.
* 6.8 Tailoring. When MIL-D-19326H is tailored in an acquisition, Appendix A
must be tailored accordingly. In particular, when Appendix A is tailored specific
attention must be given to the chain of referencing. For example, if a first tier
reference document in MIL--D-19326H is tailored out, all of the reference documents
which are tiered to that first tier reference document must be tailored out.
25
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals