 |
|||
|
|
|||
| ||||||||||
|
|  MIL-E-50748(MU)
8 August 1973
4.3 Inspection provisions
4.3.1 Submission of product. Unless otherwise specified herein,
or by the contracting officer, inspection lot size, lot formation and
presentation of lots shall be in accordance with inspection or sampling
procedures herein and submission of product provisions of MIL-STD-105.
4.3.2 Examination and tests
4.3.2.1 Components and subassemblies. All components and sub-
assemblies shall be inspected in accordance with the inspection
provisions contained in the respective specifications and Supplementary
(TDP). Assurance Provisions (SQAP) listed in the technical data package
(TDP). In the absence of SQAP's, the applicable quality assurance
provisions of MIL-F-13426 shall apply.
4.3.2.2 Functional tests. The requirements and tests in table II
shall be inspected on a 100 percent basis. All examinations and tests shall
be conducted at the standard ambient temperature.
TABLE II
FUNCTIONAL
TESTS
4.4 Special sampling. The selection of samples shall be in
accordance with section 7 of MIL-STD-lO5.
4.4.1 General. One assembly shall be selected at random by a
Government representative as a control sample from each 50 produced.
The control sample shall meet the requirements and tests in table III.
4.4.2 Environmental. Three assemblies shall be selected at ran-
dom by a Government representative as a control sample from each 50 pro-
duced `or from each month's production, whichever occurs first. The control
samples shall meet the requirements and tests in table IV.
7
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals